Konstrukcja z profilu I jest osadzona w podporach widłowych. The axial rotation is restricted on both ends while warping is enabled. The structure is loaded by two transverse forces in the middle. The verification example is based on the example introduced by Gensichen and Lumpe.
Rozważ belkę ASTM A992 W 18×50 dla stałych i równomiernych obciążeń stałych i ruchomych, jak pokazano na Rysunku 1. The member is limited to a maximum nominal depth of 18 inches. The live load deflection is limited to L/360. The beam is simply supported and continuously braced. Verify the available flexural strength of the selected beam, based on LRFD and ASD.
Na rysunku 1 pokazano belkę ASTM A992 W 24x62 o skróceniu do ścinania na końcu 48 000 i 145 000 kips od obciążeń stałych i użytkowych, odpowiednio Verify the available shear strength of the selected beam, based on LRFD and ASD.
Słup składa się z przekroju betonowego (prostokąt 100/200) oraz stalowego (profil I 200). It is subjected to pressure force. Determine the critical load and corresponding load factor. The theoretical solution is based on the buckling of a simple beam. In this case, two regions have to be taken into account due to different moments of inertia and material properties.
Konstrukcja z profilu I jest w pełni utwierdzona na lewym końcu i osadzona w podporze przesuwnej na prawym końcu. The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
Cienkościenny wspornik profilu QRO jest w pełni zamocowany na lewym końcu, a deplanacja jest aktywna. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Wspornik jest obciążony momentem na jego wolnym końcu. Using the geometrically linear analysis and large deformation analysis, and neglecting the beam's self-weight, determine the maximum deflections at the free end. The verification example is based on the example introduced by Gensichen and Lumpe.
Pręt o zadanych warunkach brzegowych jest obciążony momentem skręcającym i siłą osiową. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Provide a comparison of those values while assuming or neglecting the influence of the normal force. The verification example is based on the example introduced by Gensichen and Lumpe.
Belka jest w pełni utwierdzona (skręcanie jest ograniczone) na lewym końcu i podparta na podporze widełkowej (skręcanie jest aktywne) na prawym końcu. The beam is subjected to a torque, longitudinal force, and transverse force. Determine the behavior of the primary torsional moment, secondary torsional moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.